Regular Maintenance - Concept VR1000 Manual Del Usuario

EN
List of parts
1 Docking station 1x
2 Left and right brush 2 pairs
3 Wiping cloth
4 Spare filter
5 Cleaning brush 1x
1 2 3
6 7
USE
CHARGING
Note: If the robotic vacuum cleaner does not automatically find its docking station, you may manually sent it back to the
docking station to charge.
1. Place the docking station against a wall and remove all obstacles located on each sides of the 1.5 meter radius.
2. Put the vacuum cleaner into the docking station and make sure that their charging contacts touch. The charging of
the vacuum cleaner is indicated by a flashing white indicator light. Allow the vacuum cleaner to charge for 12 hours
before first use.
INSTALLING THE SIDE BRUSHES
1. Turn the unit over.
2. Adjust the side brush to its place once the unit is upside down.
3. Press the side brush until it clicks into its place.
4. Make sure that the side brushes can rotate freely.
CLEANING
1. You can start the cleaning by using one of the following options:
2. To start cleaning press the button.
3. Press the Start / Pause button on the remote control.
Note: If the vacuum cleaner is turned off, you need to press the
cleaner off by pressing the button for 3 seconds, until the red indicator light starts flashing.
MOPPING
1. Fill the water tank with water.
2. Insert the water tank assembly back into the vacuum cleaner. You can start the mopping by using one of the following
options:
a. Press the button to start mopping.
b. Press the Start / Pause button on the remote control.
46
6 User manual
7 Water tank
8 Remote control
9 Adapter
10 Magnetic strip
4 5
8 9 10
button for 1 second to turn it on. Turn the vacuum
USING THE REMOTE CONTROL
1. Display
2. Selecting the cleaning mode
3. Start/Pause
4. Setting the cleaning pre-set
5. Return to the docking station
6. Setting the suction power
7. Direction keys
8. Time setting
Note: Insert two supplied AAA batteries included into
the remote control before using it. Remove the back
cover and insert the batteries correctly.
In order to prevent the vacuum cleaner from
accidentally falling down the stairs, the backward
direction is not available on the remote control.
To ensure that all the correct settings are effective,
you must point the remote control at the front of the
robotic vacuum cleaner from close proximity.

REGULAR MAINTENANCE

Cleaning the dust container
1. Press the button and remove the dust container.
2. Press the release button and empty the contents of the dust container into a bin.
3. Rinse the dust container, foam filter and filter with warm water. Let it THOROUGHLY dry for 24 hours.
Cleaning the water tank
1. Once the cleaning is done, press the release button and remove the water tank.
2. Open the tank and pour out the remaining water.
3. Wash the wiping cloth and let it dry.
4. Wipe the water tank dry and set it aside.
Cleaning the main brush
1. Press the button of the main brush cover and remove the cover to access the brush.
2. Clean the main brush with a soft cloth or warm water. Dry it THOROUGHLY and reinstall it.
Cleaning the side brushes
1. Pull out the side brush.
2. Clean the side brush with a cleaning brush or cloth.
Note: Check regularly that there is no hair entangled in the brush.
VR1000 VR1000
EN
6
7
8
1
2
3
4
5
47