Publicidad
Idiomas disponibles
Idiomas disponibles
The functions of the crown
X
0
Normal position
This watch has a screw-in crown. Screwing the crown in to its normal position
(X) prevents the inadvertent adjustment of the time or date and also acts as a
double seal to prevent water from seeping into the case. To release the crown,
unscrew it by turning it to the left, where it automatically assumes position 0,
the winding position. By depressing the crown in position X and turning it to
the right at the same time, it is screwed down firmly again and secured.
Winding position
With the crown in the winding position (0), you can also wind the automatic
movement by hand. A few revolutions of the crown are enough to start the
movement. However, it is better to wind the watch by turning the crown
through approximately 20 revolutions as this will ensure maximum accuracy.
X Normal position (screwed in)
0 Winding position
1 Date and day setting
2 Time setting
1
2
Publicidad
