SCS Sentinel SOFIA M7E8 W Manual De Instalacion Y Uso página 13

ATTACHING AND CONNECTING THE ELEMENTS
• ENSURE THAT NOTHING INTERFERES WITH THE INSERTION OF SCREWS INTO THE WALL.
• DO NOT PLUG YOUR DIET AS YOUR INSTALLATION IS COMPLETED AND CHECKED.
• IMPLEMENTATION, THE ELECTRICAL CONNECTIONS AND ADJUSTMENTS MUST BE MADE IN THE
RULES OF ART BY A SKILLED AND SPECIALIZED.
• CHOOSE AN APPROPRIATE LOCATION.
• THE POWER SUPPLY MUST BE INSTALLED IN A DRY PLACE.
1
Attaching
1) Attach the exterior camera at a height of 1.5 metres mounted on a flat wall.
2) First fit the rear support. Finish by tightening the screw at the bottom of the panel.
3) Connect the camera wire (as shown in the diagram below) and insert the camera onto its support. Do not set up the
camera where it is in direct contact with the rain or sun. After installing and testing, place a clear silicon seal on the top
and sides of the exterior camera (not on the bottom) to avoid any risk of infiltration.
4) IMPORTANT : realize the setting of the melodie volume before install the monitor.
5) Attach the rear support of the monitor (at a height of 1.5 metres on a flat wall).
Connect the wires and insert the monitor onto its support.
WIRE SECTION :
Monitor-camera link
From 0 to 50 metres: use the 0.75 m² cable
CABLING DIAGRAM :
Transformer MONITOR
red
+
black
-
2
Camera - Lock / opener link
Monitor - automated system
From 0 to 10 metres: use RVV2 *1mm² cable.
A1 A2 B1 B2 C1 C2 GND VD
E8 monitor
18 Volt
adaptor
3 4
6
M7 camera
ENGLISH
5
Electric lock or opener
(optional)
5
12V / 700 mA
4 3 2 1
MONITOR
1
2
3
Camera
2
1