Operation; Pre-Start Checks - A-iPower PWE1801 Manual Del Propietario E Instrucciones De Operación

OPERATION

CAUTION:
Read the entire SAFETY and SET UP sections at the beginning of this manual
including all text under subheadings therein before operation of this product.
Improper use or treatment of Pressure Washer can damage internal components
and shorten the life of unit. Failure to follow this warning will void warranty.

Pre-Start Checks

Before every use, inspect the product, looking for damaged, loose and missing parts before
properly. Please call our customer service at 1-855-888-3598.
Starting and stoping your pressure washer.
in conjuction with the AUTO ON / OFF switch built into the product. The AUTO switch turns
system can have pressure, even when the motor is not running. Always use caution around
the pressure washer.
A. Make sure the garden hose is connected
properly, the water is turned on and
there are no kinks in the garden hose.
Do not run the product without the water
connected and on. Failure to do this can
overheat the pump and cause damage.
Squeeze and hold the trigger to release
the air trapped in the hose and pump.
Keep trigger squeezed until a steady
stream of clean water comes out of
the end of the wand. It is best to not
have a nozzle inserted when doing this
step. Engage the trigger lockout on the
gun before proceeding to the next step.
See Figure G.
Look
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
Read Manual
Figure F
Figura G
Unlook
See Figure F
B. Plug the GFCI plug into a properly
grounded receptacle. Be aware of
other electrical appliances that may be
running on the same branch circuit as
the pressure washer. If the circuit is not
rated for enough amperage to power
everything on it, the circuit breaker in
your home may trip when the pressure
washer is turned on. If this happens,
determin what else is on the circuit
and remove it while you use the
pressure washer. Reset the circuit
breaker in your home and press the
reset button on the GFCI plug to make
sure power is getting to the pressure
washer. See Figure H.
Reset
C. Turn the MAIN ON / OFF switch to
the ON position. The motor will run for a
several seconds as it builds pressure, then
is the normal operating proceedure.
13
This switch works
Figure H