A-iPower PWE1801 Manual Del Propietario E Instrucciones De Operación página 18

OPERATION
4.5 When cleaning horizontal surfaces,
occasionally use the stream to clear
the area of excess water.
4.6
spray nozzle from 8 to 24 inches
away from cleaning surface. If you
get spray nozzle too close, you may
damage surface being cleaned. It is
not recommended to get closer than 6
inches when cleaning tires.
5. Pressure adjustment
5.1 Vary your distance: To change the
being cleaned, vary the distance
between spray nozzle and the surface
being cleaned. The closer to the
pressure. As you pull away from
keep the nozzle between 8 to 24
inches from surface being cleaned
6. Use chemicals
NOTICE: Use only soaps and chemicals
designed for use with a Pressure Washer.
DO NOT USE CHLORINE BLEACH,
ACIDS OR INDUSTRIAL SOLVENTS.
Chemicals, soaps and cleaning solvents
will not siphon when a high-pressure nozzle
is used. Only use the Black (low pressure)
Nozzle when spraying detergents. Fill
Detergent Tank (if so equipped) with
prepared detergent solution and close the
cap. The Pressure Washer will draw one
gallon of detergent for every seven gallons
of water.
6.1 If your Pressure Washer is equipped
with an on board soap tank:
a. Fill the soap tank with detergent and
close the lid.
b. Change the nozzle in the wand to
Black Nozzle
c. Start the engine, and spray with soap.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
7. Rinse
7.1 Replace the nozzle with an appropriate
high-pressure nozzle (see "Selecting
The Right Nozzle" on Page 18).
Squeeze the trigger and wait for the
detergent to clear.
7.2 Keep the spray gun a safe distance
from the area you plan to spray.
7.3 Apply a high-pressure spray to a
small area, and then check the surface
for damage. If no damage is found, it is
okay to continue cleaning.
7.4 For a vertical surface, start at the top
of the area to be rinsed, working down
with same overlapping strokes as you
used for washing and applying
detergent.
8.Cleaning tips
NOTICE: Never use the Pressure Washer
garden hose inlet to siphon detergent
or wax. Leaving chemicals and cleaning
solutions inside the pressure pump could
damage it. Damages created by leaving
soaps, chemicals and cleaning solutions
inside the pump can void the warranty.
9. Stop the pressure washer
To stop the product in an emergency, turn
position. Under normal conditions, use the
following procedure:
9.1 Release the Trigger on the Spray Gun
handle.
9.2
9.3
9.4 Unplug the GFCI cord.
16