Hilti BX 3 Manual Del Usuario página 27

All manuals and user guides at all-guides.com
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Inserting the battery
Note
In order to achieve maximum battery lifetime, replace the discharged battery with a fully charged
battery as soon as you notice a clear drop in battery performance.
1. Check that the contacts on the battery and on the tool are free from foreign objects.
2. Fit the battery and make sure that it is heard to engage.
◁ Once the battery has been fitted, the charge status LEDs light for a short time.
CAUTION
A falling battery presents a hazard. If the battery is not secured correctly it may drop out and fall
while the work is in progress.
▶ Always check that the battery is securely seated.
3. Check that the battery is securely seated in the fastening tool.
5.2 Removing the battery
1. Switch the fastening tool off. → page 22
2. Press the two release buttons and hold them in the pressed position.
3. Pull the battery out of the power tool to the rear.
5.3 Removing the fastener guide
1. Switch the fastening tool off. → page 22
2. Remove the battery. → page 21
3. Pull the nail pusher down until it engages.
4. Unload the magazine. → page 23
5. Slide the fastener guide locking catch as far as it will go in the direction of the arrow.
◁ The fastener guide will be released.
6. Remove the fastener guide.
5.4 Inserting the fastener guide
1. Switch the fastening tool off. → page 22
2. Remove the battery. → page 21
3. Pull the nail pusher down until it engages.
4. Unload the magazine. → page 23
5. Slide the fastener guide locking catch as far as it will go in the direction of the arrow and hold it in this
position.
6. Slide the fastener guide into the nosepiece until it is heard to engage.
7. Release the fastener guide locking catch.
◁ The fastener guide jumps to the middle position.
8. Grip and pull the fastener guide to check that it is securely seated.
5.5 Working safely with the belt and scaffold hook
▶ Before beginning work, make sure that the belt hook / scaffold hook is securely attached to the tool.
▶ Use the belt hook / scaffold hook only when necessary. Lay the tool down in a safe place when it is not
in use for a long period.
5.6 Loading for magazine operation
WARNING
Risk of crushing! Allowing the nail pusher to snap back under spring pressure may result in finger
injuries and cause damage to the fastening tool.
▶ When pulling the nail pusher down, take care to ensure that it engages securely. Do not allow the
nail pusher to jump back under spring pressure.
Printed: 26.09.2017 | Doc-Nr: PUB / 5376263 / 000 / 00
2
3
5
4
English 21