Mounting Under Cupboard; Exhausting Mode; Recirculation Mode (With Carbon Filter) - Electrolux EFT 600-2 Libro De Instrucciones

Mounting of hood on wall
In this case 3 expansion plugs Ø 8 mm and 3
screws 5x45 are needed and must be pur-
chased separate.
Make 3 Ø 8 mm holes in the wall. 2 at points
H, 1 as desired at points I.
Insert the three Ø 8 mm expansion plugs into
the wall.
Insert 2 5x45 screws at points H but do not
tighten them completely.
Open the grid.
Fit the hood into holes H, tighten the 2 screws.
From inside the hood, insert the third 5x45
screw into hole I (Fig. 6).

Exhausting mode

Connect the air outlet to the smoke exhaust
hose
Open the suction grid (Fig. 11).
Check that the selection lever for evacuation/
recycle is in the position A - external evacua-
tion. (Fig. 8).
Refit the suction grid.
Recirculation mode (with carbon
filter)
The air outlets D (Fig. 2) must be shut.
Open the suction grid (Fig. 11).
Check that the selection lever for evacuation/
recycle is in the position : F - recycle (Fig. 7)
Mounting the circular charcoal filter
(Fig. 8):
a. Position the circular charcoal filter so that it
covers the plastic grate which protects the fan
wheel and motor.
b. Check that the small tab (1) coincides with the
arrow (2) printed on the conveyor.
c. Turn in clockwise direction.
Fig. 6
Exhausting
mode
Fig. 7
Fig. 8
Recirculation
mode
33