Sony SS-TW100ED Manual De Instalación página 2

Welcome!
Thank you for purchasing the Sony Super Tweeter
System. Before using the system, please read this manual
thoroughly and retain it for future reference.
About This Manual
The instructions in this manual are for the SS-TW100ED
Super Tweeter System.
2 GB
Precautions
On safety
Should any liquid or solid object fall into the system,
have the system checked by qualified personnel before
operating it any further.
On operation
• Do not drive the speaker system with a continuous
wattage exceeding the maximum input power of the
system.
• If the polarity of the speaker connections are not correct,
the bass tones will be weak and the position of the
various instruments obscure.
• Contact between bare speaker wires at the speaker
terminals may result in a short-circuit.
• Before connecting, turn off the amplifier to avoid
damaging the speaker system.
• Because the nominal impedance of the super-tweeter is
8 ohms, you should use an amplifier that has an 8-ohm
load impedance speaker output.
• Use the super-tweeter in conjunction with the supplied
network box to prevent damage to the unit.
• The super-tweeter grilles is not removable since the
dome material is extremely fragile. If you attempt to
remove the grille, you may damage the super-tweeter
unit.
On placement
• Do not place the speakers in an inclined position.
• Do not place the speakers in locations that are:
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight
On cleaning
Clean the speaker system with a soft cloth lightly
moistened with a mild detergent solution or water. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
If you have any questions or problems concerning your
speaker system, please consult your nearest Sony dealer.