Configuration; Ground Connection; Adding Or Removing Front And; Removing Door - Tripp-Lite SRTH6UB Manual Del Usuario

Configuration

Before proceeding with configuration, make sure the unit is properly assembled and secured to the rack
enclosure. Refer to the Assembly Instructions document for step-by-step instructions.

Ground Connection

The unit includes multiple threaded grounding points labeled
included M6 screw to connect the frame of the unit directly to your facility's earth ground connection with an 8 AWG
(3.264 mm) wire. Make sure to route the ground wire through the enclosure's frame to ensure unhindered door operation.
WARNING: Attach each enclosure to earth ground separately. Do not use the enclosure without an earth ground
connection.
Adding or Removing Front and Rear Doors
WARNING: Do not attempt to add or remove doors without assistance.

Removing Door

1
Disconnect the door's ground wire.
2
Open the door until it is perpendicular (90 degrees) to the front
of the enclosure.
3
Lift the door from the hinges and remove it from the enclosure.
To Reinstall Door, Reverse Steps 1-3
. To establish a ground, choose a grounding point and use the
1
2
3
6
90°