Product Specifications - Jacuzzi 73-BRT2-J Manual Del Usuario

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 2.4 GPM (9.0 LPM) at 20 PSI
ASME A112.18.1/CSA B125
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Drill holes in the finished deck as
shown in the diagram below.
NOTE: This kit allows up to 1-7/8 in.
deck thickness.
3. Remove the index (1), Loosen the
set screws (2) with the Hex wrench
(Hex: 3.2mm, 3) and remove the
spout assembly (4) from the con-
nector (5). Loosen the connector
(5) from the middle body (6). Adjust
the rubber washer (7), metal washer
(8) and mounting nut (9) to the
bottom of middle body (6).
4. From underneath the deck, insert the
middle body (1) with the rubber
washer (2), metal washer (3) and
mounting nut (4) through the
mounting hole. From above, thread
the connector (5) onto the middle
body (1). Tighten the mounting nut
(4) using a basin wrench, so that the
connector (5) sits flush against the
finished deck surface.
All manuals and user guides at all-guides.com
1
2
1-3/8 in.
Diamter
1-1/8 in.
Diamter
1-3/8 in.
Diamter
3
4
1
3
2
5
6
7
8
9
4
5
1
2
3
4
SPECIFICATIONS
Polished chrome, brushed nickel or oil rubbed bronze finish
Ceramic cartridges
5. Install the spout assembly (1) onto
the connector (2). Be sure the
spout assembly (1) is resting
firmly on the deck. Push down on
spout assembly (1) and tighten set
screw (3) with the Hex wrench
(Hex: 3.2mm, 4). Insert the index
(5).
6. Loosen the set screws (1) with the
Hex wrench (Hex: 2.5mm, 2) and
remove the handles (3). Loosen the
flanges (4) from the valve bodys (5
& 6). Adjust the rubber washers (7),
metal washers (8) and mounting
nuts (9) to the bottom of valve
bodys (5 & 6).
7. From underneath the deck, insert
the cold end valve (1) with the
rubber washer (2), metal washer
(3) and mounting nut (4) through
the hole on the right (cold) side.
From above, thread the flange (5)
onto the valve body (1). Tighten
the mounting nut (4) using a basin
wrench, so that the flange (5) sits
flush against the finished deck
surface. Repeat this procedure for
the hot end valve (6) on the left
(hot) side.
NOTE: The hot end valve is
identified with a label.
8. Place the handle (1) onto the
cartridge stem (2). Place the set
screw (3) into handle (1) and
tighten set screw (3) with the Hex
wrench (Hex: 2.5mm, 4). Place the
other handle onto the left (hot)
valve and install the same way.
2
5
1
5
3 4
2
6
1
3 1
3
4
4
5
6
7
7
8
8
9
9
7
5
6
1
2
3
4
8
1 3
2
www.homewerksww.com
2
4