Mounting The Hood; Install Hood Internal Fan Motor - Dacor DHDU990C/DA Serie Instrucciones Para Instalación

Installation

Mounting the hood

NOTE
Mark the hood knockouts on the wall, and then make
the necessary cutouts before the installation.
NOTE
The hood attaches to the wall by the 6 mounting
screws in the wood support mounted to the wall.
To mount the hood, follow these steps:
1. Using 2 or more people, hang the hood on the wall by
placing the 2 screws mounted in the wood support
attached to the wall through the wide portion of the
slotted holes in the back of the hood.
NOTE
If your installation uses the optional duct cover, the
vent system needs to be connected to the hood and
the duct cover mounted to the top of the hood before
you tighten the mounting screws.
2. Pull the hood down so the screws protrude through
the narrow portions of the slots, align the bottom
of the hood with the horizontal line marking the
hood bottom, level the hood, and then tighten the 2
mounting screws.

Install hood internal fan motor

1. Place the hood fan motor assembly inside the hood.
A. Wire connection
Single motor assembly
Double motor assembly
16 ENGLISH
3. Mark 2 lower mounting hole locations. Drill
4. Install the 4 - 4.2 x 19 mm screws (B) through the back
5. Connect the vent system to the hood. Seal all joint
A
A
¹⁄₈" (0.32 cm) pilot holes if the holes will be drilled
into wood studs or framing. If the holes will not be
drilled into wood, drill two ³⁄₈" (0.95 cm) pilot holes
and insert 10 x 60 mm wall anchors. Install 2 - 6 x 80
mm screws with 5.3 x 20 mm washers (D and C) into
the lower mounting holes, and then tighten.
A
B
C
B
of the hood into the wood support, and then tighten.
with clamps.
A. Mounting screws
B. 4 - 4.2 x 19 mm screws
C. 2 - 6 x 80 mm screws with
2 - 5.3 x 20 mm washers
Single motor
assembly
Double motor
assembly