Operating Instructions - NORPOLE NPPAC8KW Manual Del Propietário

(6) UP (▲) and DOWN (▼) buttons.
Used to adjust (increase/decrease) the temperature setting by increments of 2°F (1°C) between 62°F
(17°C) to 88°F (30)°C. Also used to adjust the TIMER setting between 0-24 hours.
NOTE: Temperatures can be displayed in either Fahrenheit or Celsius. To convert from one to the other,
press and hold the UP and DOWN buttons at the same time for 3 seconds.
(7) LED Display
Displays the set temperature in "°C" or "°F" and the TIMER settings. While on DRY and FAN modes, room
temperature is displayed.
Error codes:
E1 – Room temperature sensor error. Unplug the unit and plug back in. If error repeats, call for service
E2 – Evaporator temperature sensor error. Unplug the unit and plug back in. If error repeats, call for service
E4 – Display panel communication error. Unplug the unit and plug back in. If error repeats, call for service
P1 – Bottom tray is full. Connect the drain hose and drain the collected water. If error repeats, call for service
(8) SWING button (
Applicable for models with AUTO SWING feature only
Press the SWING button to turn this feature ON. Each time the SWING button is pressed, the louver will
angle up in 6° increments. Hold the SWING button down for 2 seconds to initiate the AUTO SWING
feature. During AUTO SWIGN, press the SWING button again to stop the louver at the desired angle.
COOL operation
-
Press the MODE button until the COOL indicator light illuminates.
Press the ADJUST buttons "↑" or "↓" to select your desired room temperature. The temperature can be
-
set within a range of 62°F (17°C) - 88°F (30°C).
-
Press the FAN SPEED button to choose the desired fan speed.
DRY operation
-
Press the MODE button until the DRY indicator light illuminates.
- Under this mode, you cannot select a fan speed or adjust the temperature. The fan motor will only
operate at a LOW speed.
- Keep windows and doors closed.
-
Do not install the window duct.
AUTO operation
-
In AUTO mode, the unit will automatically select COOLING, HEATING (on some models) or FAN ONLY
mode depending on the selected temperature setting and the room temperature.
-
The air conditioner will automatically control the room temperature based on the selected temperature
setting.
-
Under AUTO mode, you cannot select the fan speed.
All manuals and user guides at all-guides.com

OPERATING INSTRUCTIONS

)
7