Comunello Automation QUAD-24V-HP Instrucciones De Uso Y De Instalacion página 26

9 RESET
If it is necessary to restore the control unit to the factory configuration, press the SELECT and SET keys simultaneously for about 5
seconds; this will cause all the RED indicator LEDs to light simultaneously followed immediately by the control unit switching off.
10 DIAGNOSTICS
Photocell Test:
The control unit is prearranged for connection of safety devices in compliance with standard EN 12453 point 5.1.1.6. At each operating cycle
a functional test of the connected photocell is performed. In the case of an open circuit and/or malfunctioning of the photocell, the control unit
does not enable movement of the gate and visually signals the test failed condition by causing all the indicator LEDs to blink simultaneously. As
soon as correct operation of the photocell is restored, the control unit is ready for normal use. This operating mode guarantees failure mode
monitoring in compliance with EN 954-1 Category 2.
Commands input test:
In correspondence with each low voltage command input, the control unit is equipped with an indicator LED so that the status of the input can be checked
at a glance.
Operating logic: LED on input closed, LED off input open.
Flashing of all the LEDs of the MAIN MENU:
• obstacle for current measurement;
• obstacle for encoders;
• radio control already programmed;
• non-compliance with the rule of the first stored remote control;
Black-out test:
After programming the motor time, simulate a Black-Out and check that the leaves perform a complete opening maneuver and a complete closing
maneuver."
11 WARRANTY
11.1 - In business relationships or in case of products sold for professional use, this warranty is limited to the repair or replacement
of product parts that FRATELLI COMUNELLO SPA acknowledges as defective, through equivalent re-manufactured Products (the
"Conventional Warranty"); the warranty does not include the costs necessary for repairing or replacing the material (e.g. labour costs, rental
of equipment etc).
11.2 - The provisions contained in articles 1490 to 1495 of the Italian Civil Code shall not apply.
11.3 - FRATELLI COMUNELLO SPA warrants the proper operation of the products within the limits indicated in 1 above. Unless otherwise
agreed, the validity of the Conventional Warranty is 24 (twenty-four) months from the production date, which can be found on the products.
The Warranty shall be effective and binding on COMUNELLO only if the product has been correctly installed and maintained in accordance
with the installation and safety rules set out in the documentation provided by COMUNELLO or otherwise available on the website http://
www.comunello.com/corporate/general_conditions_sales/
11.4 - The warranty does not cover: failures or damage caused by transport; failures or damage caused by defects in the electrical
system of the buyer and/or by carelessness, negligence, inadequate or abnormal use of such system; failure or damage due to tampering
carried out by unauthorized personnel or due to incorrect use / installation (in this regard, system maintenance at least every six months is
recommended) or the use of non-original spare parts; defects caused by chemical agents and/or atmospheric phenomena.
The warranty does not cover the cost of consumables; in any event, COMUNELLO shall be entitled to a consideration for the work
performed at the Customer, where such work proves useless as the warranty did not apply or because the customer had used the
Comunello product in a negligent, reckless or incompetent manner, such that the proper use of the product could have avoided the work.
11.5 - Implementation terms: unless otherwise agreed, the right to the Conventional Warranty is exercised by showing a copy of the
purchase document (invoice) to COMUNELLO. Any defect must be notified to COMUNELLO within the time limit of thirty (30) days from
detection of the defect.
The action must be exercised within the limitation period of 6 (six) months from detection of the defect. The Product parts for which the
Customer requests application of the Conventional Warranty must be returned by the Customer to FRATELLI COMUNELLO SPA, Via
Cassola 64, 36027 Rosà (VI) Italy.
11.6 - The Customer cannot claim compensation for indirect damage, loss of profits, loss of production and in any case it cannot claim
compensation for an amount that exceeds the value of the supplied components or products. All transport costs for Products that have
been repaired or to be repaired, although covered by the Conventional Warranty, shall be charged to the Customer.
11.7 - No external work carried out by Comunello technical staff is covered by the Conventional Warranty.
11.8 - Specific amendments to the Conventional Warranty conditions described herein can be defined by the parties in their commercial
contracts.
11.9 - The Court of Vicenza (Italy) shall be the place of jurisdiction for any dispute which will be settled according to the Italian laws.
COMUNELLO ®Copyright 2021 - All rights reserved
54