Comunello Automation QUAD-24V-HP Instrucciones De Uso Y De Instalacion página 5

DIP SWITCH SW1
The SW1 Dip-Switches allow you to select the 1 or 2 motor function
and define which of the two motors starts first and which second.
SW1 SW1 SW1
ON ON ON
1 2 1 2 1 2
1 NON PRIS 2 RETARD 2 RETARD
MOTEUR EN COMPTE MOTEURS MOT. 2 MOTEURS MOT. 1
DIP SWITCH SW2
The SW2 Dip-Switches allow to change the direction of stroke
of each motor without physically intervening on the electrical
connections in the terminal block.
SW2 SW2 SW2 SW2
ON ON ON ON
1 2 1 2 1 2 1
INV INV INV INV INV INV INV
OFF OFF MOT 1 OFF OFF MOT 2 MOT 1 MOT 2
2 WIRES CONNECTION TABLE:
TAB.01
n° DESCRIPTION
1 Power supply
6A Motor power supply
2 Flashing light
4A, 5A TX photocell
4B, 5B RX photocell
6 Key selector
6B Limit switches
6C Encoder
3 Antenna
The table refers to the example of wiring shown in the ABACUS model manual for swing motors.
If the cables are of a different length than those shown in the table, the section of the cables must be determined based on the actual absorption of the connected
devices.
TRIMMER SENS: It regulates the SENSITIVTY of motors
TRIMMER SPEED: It regulates the SPEED of motors
2
INV
TRIMMER SLOWING: It regulates the slowdown speed of motors
CABLE LENGTH from 1m to 20m
2 x 1.5 mm
2 x 2.5 mm
2 x 0.5 mm
EN standard 50575, in
the list of harmonized
2 x 0.5 mm
rules for the Regulation
4 x 0.5 mm
CPR 305/2011, Com.
2016/C 209/03
3 x 0.5 mm
3 x 0.5 mm
3 x 0.5 mm
RG58
Turning with a screwdriver towards the + increases the speed of the
motor stroke during the slowing down phase
Turning with a screwdriver towards the + increases the motor speed
during the stroke.
Turning with a screwdriver towards the + increases the sensitivity and
therefore the motor will block its stroke more quickly if an obstacle is
detected.
LENGHT from 20m to 50m
2
2 x 2.5 mm
2 2 x 4.0 mm
2
2 x 1.0 mm
2 2 x 1.0 mm
2
4 x 1.0 mm
2 3 x 1.0 mm
2
3 x 1.0 mm
2 3 x 1.0 mm
Max. 20m
COMUNELLO ®Copyright 2021 - All rights reserved
2
2
2
2
2
2
2
2
33