Technical Specifications - Comunello Automation QUAD-24V-HP Instrucciones De Uso Y De Instalacion

The requirements are reported in the EN 50575: 2014 standard:
With the publication of the standard EN 50575, in the list of harmonized standards for Regulation CPR 305/2011, Com. 2016 / C 209/03,
also electric cables, already subject to CE marking for the Low Voltage Directive 2014/35 / EU, must be CE marked also under the CPR
Regulation.
In the eventualities of connections with devices connected in parallel on the same power supply line, the sizing of the cables shown in Table
1 must be re-evaluated on the basis of the absorptions and the actual distances.

3 TECHNICAL SPECIFICATIONS

Back-up Battery input:
Flashing light output:
Motors outputs:
Electric lock output:
Photocells power supply:
Indicator light output:
Working temperature:
Radio receiver:
Transmitters:
Max TX codes stored in memory:
Board dimensions:
Fuse 1 :
Fuse 2:
4 CONNECTION WITH ONE MOTOR
4.1 FORT
MOTOR 1 OUTPUT
RED
+24V
CN4
SW2 setting to have an opening to the LEFT (inner side view)
SW2
ON
1 2
INV
MOT1
COMUNELLO ®Copyright 2021 - All rights reserved
34
24 V 7A/h max.
24 V 25 W max.
24 V 2 x 75 W max.
24 V 12W max.
24 V 5 W max.
24 V 4 W max.
- 20 ÷ 55 °C
433 Mhz
18 Bit o Rolling Code
120(CODE o CODE PED/2°CH)
160 x 107 mm.
T 15 A 250V (Delayed fuse)
T 1.6 A 250V (Delayed fuse)
BLACK
GND
MOTOR 2 OUTPUT
NOT USED
SW1
ON
1 2
In this mode SW1 has been adjusted with:
1 M2 NOT
DIP1 OFF : only MOTOR 1 is considered
MOTOR
CONSID.
DIP2 ON: not used
SW2 setting to have an opening to the Rights (inner side view)
SW2
ON
1 2
INV
MOT1