Device Description - camry Premium CR 4083 Manual De Uso

should be consulted in this matter.
15. Do not insert fingers or any other objects into blender's cup when the blender is on.
16. In order to avoid injuries handle the blades carefully.
17. Watch out for long hair, scarves, neckties hanging above the cup and operating
components of device.
18. For safety reasons use only original accessories and spare parts intended for particular
blender type, available at authorised service center.
19. Handle the blades with extreme care while disassembling accessories. The blades can
cause cuts.
20. Change the accessories only when the device is switched off. Disconnect the device
from the power.
21. Do not put any products other than food and liquids in the blender cup. Do not put hot
products in the cup.
22. The device is not suitable for whipping egg whites, kneading dough or grinding meat.
23.Don't use aggressive detergents to clean the housing, as it may remove the
informational graphic symbols such as: scale, signs, safety marks, etc.
24. Do not start the empty mixing cup, without product inside.
25. MAXIMUM PERIOD OF CONTINUOUS BLENDER OPERATION IS 1 MINUTES. After
1 minutes of continuous operation stop the device and wait couple of minutes before
restarting.
26. Do not pour hot liquids (over 60 ° C) into the cup.
27. If the blades become jammed, always unplug the power cord from the electrical outlet
before removing the blockage.
28. Do not move the device while it is working.
29. Be careful when handling cutter blades, when emptying the bin and when cleaning.
30. Always disconnect the blender from the power supply when it is left unattended and
before assembling, disassembling or cleaning.

DEVICE DESCRIPTION:

1 – Measurement cup (50ml)
4 – Safety lock
7 – Motor base
I - DEVICE OPERATION
Before first use:
1. Remove all stickers from the motor base (7), jug (5) and lid (2) of the blender.
2. Wash the jug (5) and the lid (2) in warm water with washing-up liquid and dishcloth. Dry it in the inside and outside.
3. The blender is used to:
a) blend fruits and vegetables - before blending, you must cut the food into 10-15mm slices.
b) crushing the ice - the quantity of ice cubes in the glass jug should be about 10 pieces, and size of the ice cube should not exceed
30*23*23mm.
4. Do not allow for continuous operation of the blender for longer than 1 minute. Later let the device cool down for 10 minutes.
5. Never use boiling liquids nor run the appliance empty.
6. Overfilling can block the operation. Please turn off the unit and pull out the plug from the power socket. Take some of the food out of
the jug (5), then connect again to the mains. Device is ready for use.
II - ASSEMBLY
Jug assembly: seal ring, glass jug and blades are already assembled and ready to use. Measurement cup (1) and lid (2) must be set up
before each use.
1. First, place the jug(5) on the motor's base (7). Arrow symbol below the handle must point in to open padlock symbol (4). Turn the jug
2 – Lid
5 - Glass jug 1,5 liters
8 – Speed adjustment knob
3 – Lid ring
6 – Blades