Box Contents; Getting Started; Fitting The Batteries; Battery Condition - Elcometer 270 Guia Del Usuario

2 BOX CONTENTS

Elcometer 270 Pinhole Detector

Signal Return Cable, 4m (13')

Standard Wand Accessory (flat sponge)

AA Batteries, x3

Calibration Certificate (if ordered)

User Guide


3 GETTING STARTED

3.1 FITTING THE BATTERIES

Each gauge is supplied with 3 x AA alkaline batteries.
To insert or replace the batteries:
1 Unscrew the battery cap (turning
anti-clockwise).
2 Insert 3 batteries taking care to ensure
correct polarity.
3 Refit the battery cap.

3.2 BATTERY CONDITION

The battery condition is indicated by the LED on
the front keypad (a):
 When the batteries contain adequate
charge, the battery condition LED is not
illuminated.
 When the batteries reach the final 10% of
their capacity, the battery condition LED
illuminates continuously.
 When the battery condition LED flashes,
the batteries are exhausted and new
batteries must be fitted.
Note: Batteries must be disposed of carefully to avoid environmental contamination.
Please consult your local Environmental Authority for information on disposal in
your region. Do not dispose of any batteries in fire.

3.3 SWITCHING ON / OFF

Press and hold the on/off key (b). The detector will emit an audible
signal and switch on or off.
en-3
R
a
www.elcometer.com
b