2.1
Precautions
The Constructor declines all responsibilities if the precautions below are not taken.
The accomplishments concerning working environment safety and health regulations indicated by the current
laws (2003/10/CE Directive, 2002/44/CE Directive and 81/2008 Law Decree) have to be carried out either by the end-
user or by the employer: supplying the adequate individual protecting devices, informing about working risks,
performing sanitary survey, etc...
The over-exposure to the vibrations may cause neurovascular lesions to people suffering from circulatory disor-
ders. In case of symptoms which could be referred to, such as an over-exposure, a specialist has to be contacted.
These symptoms can be torpor, loss of sensitivity, sharp pains, itch, strength reduction or loss, complexion dis-
coloration or structural modifications. This usually happens in one's hands, wrists and fingers.
2.1.1
Results of the tests carried out according to the Laws
1) ELECTROMAGNETIC COMPABILITY LEVEL
The equipment complies with the 2004/108/CE Directive and the following modifications.
2.2
General precautions
Do not use the tool indoor or in case of potentially explosive atmosphere.
•
The tool is for a professional use only.
•
Use the tool only with the accessories indicated by the Manufacturer.
•
Use the tool only from the ground, working in a stable and safe position.
•
Always use adequate clothing as called for by the job. Wear tight clothing. Do not wear ties, necklaces or belts or keep
loose long hair which may get caught in the moving parts. Use anti-sliding shoes and protective gloves and goggles.
•
Wear a noise-abatement headset.
•
Do not operate, service or repair the equipment if you are under the influence of medicines, alcohol or drugs which
could impair your alertness or co-ordination.
•
Only well trained and qualified personnel, who have read the use and maintenance manual carefully, are allowed to
use the tool.
•
Keep children and animals away from the tool.
•
Never alter the safety and protective devices.
•
The operator is the only person responsible for injuries caused to other people or for damages caused to their proper-
ties.
•
Do not use the tool when you are in unstable position or off balance.
•
It is forbidden to operate the tool on ladders.
•
Before any routine maintenance operations, read the use and maintenance manual carefully. For any maintenance
operation which is not indicated in this manual, please contact one of the Manufacturer Authorised Service Points.
•
Use the tool just for the purposes indicated in Ch. "Product description". Any other kind of use may cause injuries.
•
Store this manual carefully and read it before any tool use.
•
Keep all the stickers with the safety indications in perfect conditions.
•
Avoid working in bad weather conditions, such as fog, heavy rain or strong winds.
2.3
Use
•
Carry out a complete recharging cycle before using the battery unit (2) for the first time in the working season.
•
Do not leave the unit in the rain. Store it in a dry place.
•
Do not leave the battery unit (2) under the sun rays. Do not expose it to microwaves sources. It shall not be subject to
hits or high pressure. Do not put it into the water or keep it in a humid place. Keep it away from heat sources (>60°C)
and flammable stuff.
•
Do not use a battery-charger which is different from the one supplied by the Manufacturer, since it could cause serious
damages to the tool and injuries to the operator. In case of doubt, check if the battery-charger model is one of those
listed in par. 3.6.
•
Do not open the battery unit (2) or the corresponding battery-charger. In case of problems, do not use the component
and immediately carry the unit to a Campagnola Authorised Service Point for a reparation or a replacement.
•
Do not remove the 'Garanzia/Warranty' label for any reason, otherwise the warranty becomes void.
•
It is recommended that the same operator does not use the unit for a long time per day. Two operators should alter-
nate hour by hour. A continuous use can make the operator very tired.
Use and maintenance manual – Translation of
original Instruction Rev.: 02, Data 08/11/2021
Pag. 17