Safety Devices; Starting; Fitting The Battery Set Onto The Backpack; Starting The Unit - CAMPAGNOLA Li-Ion 700 Manual De Uso Y Mantenimiento

3.7

Safety devices

Built-in safety device – Automatic switch-OFF: if not used for over 20 minutes and with the charge level over 20%,
•
the power supply is switched off.
• With the charge level of the battery below 20%, the automatic switch-off occurs in 5 minutes.
• Use the ON/OFF button (4) to restart the battery.
• Built-in protection device: Protects the battery set avoiding that the voltage increases or decreases too much, consid-
ering the indicated thresholds.
4.1

Starting

Remove the components from the packaging.
•
Recharge the batteries (2) (see par. 5.3).
•
Fit the battery set (2) onto the backpack (3) by following the instructions in par. 4.2.
•
Plug the cable (1) taking care of the male/female connections.
•
4.2

Fitting the battery set onto the backpack

• Remove the backpack (3) and the battery (2) from the packaging.
• Insert the fixing supports (10) into the lower pocket of the backpack.
• Insert the fixing belts of the backpack into the corresponding fixing slots on the top of the battery (9)
• Fasten the fixing belts inside the backpack (3).
5.1

Starting the unit

• Wear the backpack (3) and adjust the belt length by means of the buckle.
• Adjust the braces buckle so that they cannot slip from the shoulders.
• Turn the button ON (4).
• Use the unit only for the purposes described in par. "Description of the Product". Any other use may cause
injuries.
• The backpack (3) shall be positioned in such a way that the 90% of its weight is supported by the operator's
waist instead of by his back.
• The braces shall be used to improve the weight balancing (10%).
5.2

Display

After quickly pressing the ON/OFF button (11) on the display (9), the charge level will be visible for about 5 seconds with
the following modes:
• 4 led bars – 80/100% charge level
• 3 led bars – 60/80% charge level
• 2 led bars – 40/60% charge level
• 1 led bar – 20/40% charge level
• 1 flashing led light – charge level is lower than 20%
• All flashing LED lights with repetition each second = Error status.
If any undervoltage is detected, it persists even if the battery is switched off and then on again, until it reaches at least the
20% of its status of charge (SoC).
Pag. 20
Use and maintenance manual – Translation of
original Instruction Rev.: 02, Data 08/11/2021