Modifiers; Option Buttons; Acoustic Signal - Bosch Nexxt DLX Manual Del Usuario

No final spin
The indicator light no final spin" is
lit red.
For delicate laundry, the water
remains in the machine after the last
rinse.
Use this setting to avoid creasing if
the clothing cannot be taken out of
the washing machine immediately
upon completion of the cycle.
CAUTION
Before unloading you must drain
the remaining water by selecting
Drain or Spin and starting the
machine.

Modifiers

Spin Selection
Preset cycle setting of max. spin
speed can be changed.
Press this button until the desired
setting lights up.
Start in
Before starting a program you can
modify by when the cycle should be
started.
Press Start in button. The display
shows the start time 0:00.
The time can be delayed up to a
maximum of 19 hours (with 1 hour
increments) by pressing the Start in
button again.
The Start time begins running
immediately after pushing the
Start/Pause button. This is
indicated by the points between the
digits flashing.
i
Changes to the Start time are
possible at any time, press the
Start in button until the new
time appears.
i
If the program is changed or if
the program is interrupted, the
preselected Start time is also
interrupted. The Ready in time
of the program is displayed.
The Start time must be
reselected.

Option buttons

Bleach
When this button is pressed,
a bleach cycle will be added to
the selected cycle.
The washing cycle time is extended
accordingly.
Rinse Plus
When this button is pressed, an
additional rinsing cycle will be
added to the selected cycle.
Washing cycle time is extended
accordingly.
Power Wash
The Power Wash option is
recommended for use ONLY for
heavily soiled clothes that
require the removal of tough,
ground-in protien-based stains.
It is NOT recommended to use the
Power Wash option with other
cycles when laundering normal or
lightly soiled clothes.
Washing time is extended.
Only cold water is introduced to the
drum. The washing machine then
heats the water to the selected
wash temperature. By raising the
temperature from cold up to the set
temperature all components of the
detergent are activated in stages for
best stain removal and cleaning
results.

Acoustic Signal

An acoustic signal indicates pro
gram statuses (e.g. start/end of
program and operating faults.)
To activate the signal:
q Select a program.
q Press two of the Option
Buttons(e.g. Bleach and Rinse
Plus) until a long signal is
emitted.
To deactivate the signal:
q Select a program.
Press two of the Option
q
Buttons and hold until a short
signal is emitted.
i
Do not activate/desactivate the
acoustic signal during a cycle.
19