Levelling Procedure; Electrical Connection - Bosch Nexxt DLX Manual Del Usuario

q completely remove transport
bolts (bolt, spring, washer and
bushings) by reaching through
the open washing machine door
and pulling the drum slightly for
ward to loosen, then pull out from
the back.
If the bushings do not come out
q
when removing the screws, place
screws back into the bushings
and carefully try again. It is im
portant to do this with the
screws, otherwise the bushings
will not come out properly.
q Insert the covers until they snap
in completely.
Storing the transport bolts
Always keep the transport bolts for
future transportation of the ap
pliance (such as when moving out).
Store the transport bolts with
q
the washer and bushing
attached.
8
Leveling procedure
Each foot of the appliance or
pedestal must be placed firmly on
the ground to prevent the washing
machine from wobbling.
Level the washing machine front to
back and side to side with the four
height adjustable feet and a bubble
level:
d
CAUTION
TO AVOID RISK OF INJURIES-
Take care when using the
wrench.
q Loosen the counter nut 1 using
the wrench for levelling.
q Adjust the height by turning the
height adjustable foot 2.
q Tighten lock nut 1 against the
housing.
q Level machine as low as
possible.
q Fine tune the leveling by
placing a small load in the
machine, starting the machine
in spin cycle and then leveling
again.

Electrical connection

GROUNDING INSTRUCTIONS
This appliance must be grounded.
In the event of a malfunction or
breakdown, grounding will reduce
the risk of electrical shock by pro
viding a path of least resistance for
the electric current. This appliance
features a cord with an equipment
grounding conductor and a ground
d
ing plug. The plug must be plugged
into an appropriate outlet which has
been properly installed and
grounded in accordance with all
local regulations and ordinances.
d
WARNING
Improper connection of the
equipment grounding conductor
may result in electric shock.
Have the appliance checked by
a qualified electrician or service
technician if you are in doubt as
to whether the washer has been
properly grounded.
Do not modify the plug provided
with the appliance - if it will not fit in
the outlet, have a proper outlet
installed by a qualified electrician.
d
WARNING
The washing machine must only
be connected to an individual
branch circuit via a socket which
has been properly installed and
grounded.
The household electrical voltage
must correspond to the voltage
specification on the washing
machine (rating plate, see page 27).
Connection specifications as well
as the required fuses are stipulated
on the appliance rating plate.
Volts Hertz
110-120 60
d
d
Amperes Watts
15 1350
(max.)