Stopping The Tool; Battery Charging - CAMPAGNOLA T-FOX Manual De Uso Y Mantenimiento

Do not use any recycled oil. It could damage the lubrication pump.
Before any oil supply, clean the area around the plug (14), so that any impurities may enter the reservoir (16).
Check the lubrication operation at each refueling. Direct the bar (2) towards a light surface, keeping it about
twenty centimeters away. Run the chain at half speed for several minutes. The surface will have to show oil
traces.

Stopping the tool

• Release the operating lever (7).
• Switch off the tool by means of the ON/OFF button (11).
• Remove the battery (18) by pressing the releasing plates (19).
Never put the tool onto the ground before the chain (1) has stopped its movement
Let the chain (1) and bar (2) cool for a few minutes before checking the chain (1) tension.

Battery charging

• Connect the battery (18) to the battery charger (20) and the plug of the charger to the socket. Avoid using electrical
extension cables, as they are a source of electrical risks.
• The battery charger LED lights (21) become red during the recharge. When the battery is charged up, the LED light
(21) becomes green.
Each recharge connector (22) has a corresponding indicator on the battery charger.
The batteries are charged in sequence, the one after the other, not simultaneously.
The LED light indicator (21) becomes red during the recharging operation, green when recharge is over.
Recharge of 3 connected batteries:
As soon as the first battery is charged
up (green LED light (21)), the recharge
of the second battery starts, followed
by the recharge of the third one.
Use and maintenance manual – Translation of
original Instruction.: 01, Date 24/11/2021
Page 35