Sauder Shoal Creek 411236 Manual Del Usuario página 12

Step 8
Fasten the TOP (K) to the MOLDINGS (L2, M2, and N2).
å
Use three BLACK 1-7/8" FLAT HEAD SCREWS (2S).
Fasten the BACK (I) to the MOLDINGS (L2, M2 and N2).
å
Use twelve BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: There are no pre-drilled holes in the MOLDINGS.
å
The SCREWS will tighten into the grooves.
BLACK 1-7/8" FLAT HEAD SCREW
(3 used in this step)
Page 12
2S
The holes are closer to this edge.
K
L2
M2
N2
Cut-out
411236
L2
I
BLACK 9/16" LARGE HEAD SCREW
(12 used for the BACK)
www.sauder.com/services
1S