DeWalt D25333 Manual De Instrucciones página 24

ENglIsh
Fig. C
9
3. Release the button to lock rod into position. When
drilling with the depth rod, stop when end of rod
reaches surface of material.
Bit and Bit Holder

WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.

WARNING: Do not attempt to tighten or loosen drill
bits (or any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to the
chuck and personal injury may occur.
The rotary hammer can be fitted with various chisel bits
depending on the desired application. Use sharp drill
bits only.
Bit Reccomendations
• For wood, use twist bits, spade bits, power auger bits or
hole saws.
• For metal, use high-speed steel twist drill bits or
hole saws. Use a cutting lubricant when drilling metals.
The exceptions are cast iron and brass which should be
drilled dry.
• For masonry, such as brick, cement, cinder block, etc.,
use carbide-tipped bits rated for percussion drilling.
SDS Plus Bit Holder (Fig. D)
NoTE: Special adapters are needed to use the SDS Plus
bit holder with straight shank bits and hexagonal
screwdriver bits.
To Insert a Drill Bit or other accessory:
1. Insert the shank of the bit about 3/4" (19 mm) into
SDS Plus tool holder 7 .
2. Push and rotate bit until it locks in place. The bit will be
securely held.
3. To release bit, pull the sleeve
the bit.
22
All manuals and user guides at all-guides.com
10
To remove the bit, pull back the locking sleeve and pull the
bit out.
Keyless Chuck (Fig. E, F)
D25334
On some models, a keyless chuck can be installed in place of
the SDS Plus bit holder.

Replacing the sDs plus Bit holder with the Keyless
Chuck
1. Select hammering only mode (see Operation Modes),
2. Turn the locking collar
3. Push the keyless chuck
4. To replace the keyless chuck with the SDS Plus bit
Fig. E
back and remove
8
To Insert a Drill Bit or other accessory in Keyless
Chuck
1. Grasp the sleeve
2. Rotate the sleeve counterclockwise (as viewed from the
3. Insert the accessory about 3/4" (19 mm) into the chuck
Fig. D
8
7
WARNING: Never use standard chucks in the rotary
hammering mode.
this locks the spindle to prevent it from rotating when
unlocking the removable tool holder.
13 into the unlocked position
and pull the installed bit holder off.
onto the spindle
14
turn the locking collar into the locking position.
13
holder, first remove the keyless chuck the same way as
the SDS Plus bit holder was removed. Then replace the
SDS Plus bit holder the same way as the keyless chuck
was replaced.
13
15
14
8 of the chuck with one hand and use
the other hand grasping the base of the chuck.
front) far enough to accept the desired accessory.
and tighten securely by rotating the chuck sleeve
and
15
13