Overload Clutch - DeWalt D25333 Manual De Instrucciones

clockwise with one hand while holding the tool with
the other hand. Continue to rotate the chuck sleeve
until several ratchet clicks are heard to ensure full
gripping power.
Be sure to tighten chuck with one hand on the chuck sleeve
and one hand holding the tool for maximum tightness.
To release the accessory, repeat Steps 1 and 2 above.
Fig. F
8
OPERATION

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. A, G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the mounted
side handle, with the other hand on the main handle.
Fig. G
SHOCKS Active Vibration Control® System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool actuate faster and active
vibration control will not engage.
All manuals and user guides at all-guides.com

Overload Clutch

In case of jamming of a drill bit, the drive to the drill spindle
is interrupted by the overload clutch. Due to the resulting
forces, always hold the tool with both hands and take a
firm stance. After the overload, release and depress the
trigger to re-engage drive.

Operation Modes (Fig. A)


Your tool is equipped with a mode selector dial
select the mode appropriate to desired operation.
symbol
To select an operating Mode:
1. Depress the mode selector release button
2. Rotate the mode selector dial so that the arrow points to
NoTE: The arrow on the mode selector dial
pointing at a mode symbol at all times. There are no
operable positions in between. It may be necessary to briefly
run the motor after having changed from 'hammering only'
to 'rotary' modes in order to align the gears.
Performing an Application (Fig. H)


1. Choose and install the appropriate chuck, adapter, and/
2. Using the mode selector dial
3. Adjust the side handle
WARNING: Drill may stall if overloaded causing a
sudden twist. Always expect the stall. Grip the drill
firmly to control the twisting action and avoid injury.
WARNING: Do not select the operating mode when
the tool is running.
CAUTION: Never use in Rotary Drilling or Rotary
Hammering mode with a chisel bit in the bit holder.
Personal injury and damage to the the tool may result.
Mode
Screwdriving
Rotary Drilling
Drilling into steel, wood
and plastics
Rotary Drilling into concrete
hammering and masonry
hammering
Light chipping
only
the symbol corresponding for the desired mode.
WARNING: TO REDUCE THE RISK OF PERSONAL
INJURY, ALWAYS ensure workpiece is anchored or
clamped firmly. If drilling thin material, use a wood
"back-up" block to prevent damage to the material.
WARNING: Always wait until the motor has come to
a complete standstill before changing the direction
of rotation.
or bit onto to the tool. Refer to Bit and Bit Holder.
3 , select the mode
appropriate to desired application. Refer to
Operation Modes.
5 as necessary.
ENglIsh
to
3
application
4 .
3 must be
23