Protecting The Environment - DeWalt D25333 Manual De Instrucciones

ENglIsh
Fig. H
3 1
5
4. Place the bit/chisel on the desired location.
5. Depress the trigger switch 1
6. To stop the rotary hammer, release the switch.
Recommendations for Tool Operation
• Large (5/16" to 1/2" [7.9 mm to 12.7 mm]) holes in steel
can be made easier if a pilot hole (5/32" to 3/16" [4 mm
to 4.8 mm]) is drilled first.
• When drilling, always apply pressure in a straight line
with the bit, but do not push hard enough to stall the
motor or deflect the bit. A smooth even flow of material
indicates the proper drilling rate.
• If drilling thin material or material that is prone to
splinter, use a wood "back-up" block to prevent damage
to the work piece.

WARNING:
• Do not use this tool to mix or pump easily
combustible or explosive fluids (benzine,
alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
24
All manuals and user guides at all-guides.com
Accessories

Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Repairs
.
The charger and battery pack are not serviceable.


Protecting the Environment

Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions.
Voltage
Frequency
Power
No Load Speed
Impacts per Minute
Impact Energy
Drilling Range
Drill Capacity
Concrete
Steel
Wood
Vibration Measurement
Weight
WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D WALT factory service center
e
or a D WALT authorized service center. Always use
e
identical replacement parts.
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste.
Specifications
D25333
B3
120 V
50-60 Hz
950 W
0–1150/min (rpm)
0–5200 ipm
3.5 J
1/2" (13 mm) - 1-1/8" (28 mm)
Max. 1-3/16" (30 mm)
1-1/8" (28 mm)
1/2" (13 mm)
1-3/16" (30 mm)
6.9 m/s
3.7 kg (8.1 lbs)
WALT
e
2