Air Filter; Changing The Engine Oil - Garland ROLL & COMB 602 QG-V21 Manual De Instrucciones

English

8.2.1. AIR FILTER

Dirt on the air filter will reduce the performance of the
machine.
Check and clean this item. If you observe damage or
alterations in the filter, replace it with a new one.
CLEANING THE FILTER (depending on the model)
Cartridge filter
The cartridge air filter is protected by a second oiled
foam filter.
The foam filter can be cleaned as follows:
- Remove the protective cap from the filter.
- Take out the filter.
- Clean the filter with soapy water.
- Rinse the filter with plenty of clean water.
- Let the filter dry.
- Once dry, moisten it with 2 drops of oil (If you
moisten the filter with too much oil, the machine
may not start).
- Install the filter in the machine.
- Put the protective cap on.
If when cleaning the foam filter you find that the
cartridge filter is very dirty, replace it with a new one.
Note: The engine should never run without the air
filter installed .

8.2.2. CHANGING THE ENGINE OIL

Perform the oil change only while the engine is still
hot.
WARNING! You must not throw old oil in a pipeline
network or on the Earth. The contamination of
groundwater and water tables is subject to heavy
fines. There are special collection places at service
stations. If not, any municipal authority will give you
the relevant information.
Note: You have two procedures at your disposition to
empty the engine oil. You can drain the oil
by loosening the drain screw (Y2) located at the base
of the filling canal or you can use the Garland engine
oil cleaner (ref.: 7199000020, not included with the
machine, which can be found at your nearest Garland
dealer) and suck the oil through the filling tube (Y1) of
the machine. For easy implementation, cleaning and
safety we recommend that you pick up the oil.
To change the oil:
- Place the machine on a flat, horizontal and
uncluttered surface.
Empty the engine oil:
- If it sucks the used oil: remove the engine oil plug
(Y1) and vacuum the motor oil by inserting the
Garland vacuum cleaner tube (REF.: 7199000020,
not included with machine) to the bottom.
- If you choose to empty the drain (Y2) through the
drain plug, please note the trajectory that the oil
will take into the chassis, place a large container to
catch all of the oil before it spills on the ground.
- We recommend that you put a big plastic covering
on the area in which you will change the oil so that
oil does not fall on the ground. Once the work area
is prepared, remove the filling cap (Y1) and remove
the (Y2) oil drain plug and slightly tilt the machine
so that the oil comes out and falls into the
container.
- Once all of the oil has been drained, put the drain
plug back in the machine.
42/100
Y1
Y2