Uline H-4954 Manual De Instrucciones página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CEILING MOUNT
NOTE: The ceiling surface must be flat and
level with the floor.
1. The height is pre-determined by your ceiling height.
IMPORTANT! Make sure the ceiling height is at
least 3" higher than your curtain height.
2. Place a mark on the ceiling
where both ends of the track
will fall (A).
3. Connect those marks with a
straight line (B).
4. Place the
Ceiling
Support
Connector (C)
on the ceiling.
Mark the two
mounting
holes. Remove
the bracket, drill the two holes and screw the
bracket to the ceiling.
WALL MOUNT
1. On the bulkhead, place
a mark 5" higher than the
height of your curtain on
one side (A).
2. From that
D
point, stretch
a line level to
the opposite
side and
place a
mark (B). That distance should be the length of your
Straight Track assembly.
3. Connect the marks with a straight level line (C).
4. Place each Universal Mounting Bracket on the wall
so the top edge of the bracket is even with the
line (D). Mark the two mounting holes. Remove the
bracket, drill the two holes and screw the bracket to
the wall.
SUSPEND MOUNT
1.
Using this method, you will need beam clamps
and threaded rods that are not included with your
hardware.
PAGE 2 OF 6
MOUNTING
B
A
C
C
B
1-800-295-5510
2. Measure the distance
from bottom of the
roof beam or truss
(A). Subtract from that
amount the height
of the curtain plus
3". The threaded
rods should be 2"
longer than that final
A
measurement.
IMPORTANT! Ensure all threaded rod ends are
level with one another.
3. Place a nut 1" up from the bottom of the threaded
rod (B). Next, place a washer over the rod and
Universal Mounting Bracket. Then, place a washer
and nut on the threaded rod. Tighten the assembly.
CURTAIN ASSEMBLY
INSERTING NYLON ROLLERS WITH HOOKS
1.
Place each
roller into the
open end of
the track. The
number of rollers must be equal to the number of
grommets on the top edge of the curtain.
A
ATTACHING TRACK TO
BRACKET/SUPPORT
CONNECTOR
1.
First, remove the Track Holder
Plate from each of the Ceiling
Support Connectors.
2. Next, place the Straight Track
(assembly) into the Ceiling
Support Connector.
3. Finally, replace the Track
Holder Plate to each of the
Ceiling Support Connectors
and tighten the locking nut so
the track is secure.
HANGING THE CURTAIN
1.
Place each curtain grommet
over a roller hook (A).
uline.com
Beam Clamp
B
A
Holder
(Assembly if
multiple tracks)
A
0521 IH-4954
Track
Plate
Straight
Track

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

H-4955H-6337H-633H-6339

Tabla de contenido