Troubleshooting Guide - Kenwood HMP50 Instrucciones

4 Shape the dough into a loaf,
or rolls, and place on greased
baking trays. Cover with
oiled cling film and leave
somewhere warm until it has
doubled in size.

Troubleshooting Guide

Problem
Handmixer does
not operate.
Kneader with
collar cannot
be inserted into
socket.
Handmixer
starts to slow
or labour during
processing.
Excessive
splashing
or flour
spray during
processing.
Unable to
remove tools
from sockets.
Pulse button
does not
operate
Cause
No power.
Fitting kneader to
wrong socket
Speed selected
too low.
Recommended
quantity
exceeded.
Speed selected
too high.
Bowl too shallow
or too small for
ingredients being
processed.
Speed selector
not in 'O' position.
The motor will
only operate for
as long as the
control is held in
position.
7
5 Bake in a preheated oven at
230°C/450°F/Gas mark 8 for
20-25 minutes (for a loaf) or
10-15 minutes (for rolls). When
ready, the dough should
sound hollow when tapped on
the base.
Solution
Check appliance is plugged
in.
The kneader with the collar
will only fit into the
socket.
Increase speed.
Refer to Recommended
Usage Chart for speeds
and quantities to process.
Do not operate for longer
than 3 minutes without a
15 minute rest period with
doughs or heavy cake
mixes.
Select a lower speed
initially and increase as the
mixture thickens.
Select an appropriate sized
mixing bowl.
To remove the tools, make
sure the speed selector
is in the OFF "O" position
and unplug the handmixer.
Press the Tool SureEject™.
Slide the speed selector to
the (P) position to use in
short bursts at maximum
speed.