Bosch Integra SHX68M05UC Instrucciones De Uso página 19

Dishwashers may occasionally exhibit problems that are unrelated to a malfuncion of the dishwasher itself. The following informaion may help you
with a dishwasher problem without involving a repair professional.
Problem Cause
Interrupion of electrical power supply to dishwash
er or blown fuse.
Child lock acivated (select models).
The door may have been closed without irst select
Default factory seings alert the customer that the cycle
beeping (end
has completed by beeping. This feature can be deaci
of cycle signal)
vated if so desired.
A fuse may have been blown or circuit breaker
Note: For models with controls on the top porion of the
Cycle ime can vary due to soil and water condi
long ime ions.
Rinse agent dispenser is empty.
Note: Refer to "Cycle Chart Data" secion in this manual
for typical cycle length.
geing clean
Improper use of detergents.
Selected wash cycle is not suitable for food soil
condions.
Rinse agent dispenser is empty. (Rinse agent indica
geing dry tor is acivated).
Improper loading of dishes.
Note: Plasic or Telon do not typically dry as completely
as other items due to their inherent properies.
Odor Food debris is present at the botom of the dish
Food paricles are present near the door seal.
Dishes let too long in unit before running a cycle.
Residual water is present at the botom of the dish
All manuals and user guides at all-guides.com
Acion
To adjust the volume or deacivate, refer to "Cycle Compleion Sig
nal" secion in this manual.
Note: Select models ofer an extra heaing opions to improve drying
performance. Refer to "Wash Cycle opions" under the Operaing
the Dishwasher secion of this manual.
Note: If odor sill persists, run the Normal/Regular cycle unil it lushes
and interrupt the cycle and place an 8 oz. cup of disilled white vinegar
soluion on the top rack and then inish the cycle.
To reset, refer to "Canceling or changing the cycle" secion in this
To reset, refer to "Delay Start" secion in this manual.
Deacivate the child lock. Refer to "Child Lock" secion in this
manual if applicable.
Check the fuse or circuit breaker box and replace the fuse or re
set the breaker if necessary.
Before staring a cycle, run hot water faucet at the sink nearest
Sensors in the dishwasher automaically increase the cycle ime
Verify dishwasher is connected to hot water supply plumbing.
Ensure that spray arm movement is not blocked by hand rotaing
Remove the spray arms and clean according to "Check/Clean
the Spray Arm Nozzles" in Care and Maintenance secion of this
ness. Refer to Table under "Adding Detergent and Rinse Agent".
Clean the ilter. Refer to "Check/Clean the Filter System" under
Care and Maintenance secion of this manual.
Rearrange load such that water spray can reach all items in the
dishwasher. See also "Preparing and Loading" secion of this
Refer to "Wash Cycle" secion in Operaing the Dishwasher sec
ion of this manual.
Add rinse agent. The use of rinse agent improves drying.
Rearrange load to ensure items are not nested. Refer also to the
"Preparing and Loading" secion of this manual.
Rinse and Hold seing does not include drying cycle,
Remove the ilters and clean according to the "Check/Clean the
Filter System" secion of this manual.
Refer to "Clean the Door Gasket and Door Seal" in the Care and
Maintenance secion of this manual .
Run a Rinse/Hold cycle if you do not intend to immediately wash
Ensure the unit has completely drained from the last cycle. Refer
to the "Canceling or changing the cycle" secion of this manual.
Remove any obstrucions from the drain hose by calling qualiied