Drum/Base Assembly - RIDGID 1600RV Manual Del Usuario

SP6940-1 1600RV0_1_SP6940-1 1/22/15 2:28 PM Page 6

Drum/Base Assembly

If any parts are missing or damaged
contact Customer Service.
Do not assemble until you have all the
parts.
1. Installing Cap Nut
a. Place one cap nut on end of each
axle.
b. Tap gently with hammer until fully
seated.
c. Place one wheel on each axle with
smooth portion of wheel facing the
cap nut.
2. Slide the open end of the axle through
the hole in the side of the power base
until it stops. Install the axle retainer
over the axle with the two screws
provided.
3. Repeat Step 2 for the other rear
wheel.
All manuals and user guides at all-guides.com
6
Axle (2)
Wheel (2)
Cap Nut (2)
Cap Nut
NOTE: Smooth
side of the wheel
to the outside.
Screw (2 each)
Axle Retainer (2)
Screw
(2 each)
Axle
Retainer
Power Base