Trouble Shooting - Grizzly Tools ERV 1201-31 ZV Set Traducción Del Manual De Instrucciones Original

GB

Trouble shooting

Problem
Abnormal noises,
clatter or vibra-
tions
Implement does
not start
Motor fails
Work result not
satisfactory
60
Possible cause
Foreign body on cylinder
Damaged sprung tines or cyl-
inder knives
Cylinder incorrectly mounted
Toothed-belt slip
No power
Defective start lever or re-
lease button
Carbon brushes worn out
Motor defective
Blocked by foreign body
Grass is too long
Clogged discharge
Overload protection tripped
Sprung tines of aerator cylin-
der worn out
Knives of verticutor cylinder
blunt or damaged
Toothed belt defective
Transport Position or incor-
rect Working Position se-
lected
Grass is too long
Remedy
Remove foreign body
Exchange cylinder
Install cylinder correctly (see chap-
ter on exchanging the cylinder)
Repair by After-Sales Service
Check power socket, cable, line;
repair only by qualified electrician
Repair by After-Sales Service
Remove foreign body
Mow beforehand; see chapter "Op-
eration"
Clean discharge
Allow implement to cool down for
about 1 minute
Exchange cylinder
Exchange cylinder
Repair by After-Sales Service
Select Working Position or Read-
just Position (see chapter "Setting
the Working Positions)
Mow beforehand; see chapter "Op-
eration"