Century 1010 Manual Del Usuario página 7

MODEL 87302 & 1200
Step 1: Set RATE SELECTOR (Top
Switch)
Select "Low" for 2 Amp, 12 Volt
Charging and 6 Amp, 6 Volt Charging.
Select "High & Start" for 30 Amp
Charging (6 and 12 Volt) and Engine
Starting.
Note: If you are attempting to start a car with a weak
battery, for best results, charge the battery for 5-15
minutes. Crank the engine for 3-4 seconds. If engine fails
to start, charge battery for another 5-15 minutes and
attempt to start the engine again.
K
MODELS 1060, 1160, 87106, 87122, 87128,87151 & YA510B ONLY
When in the one of the automatic shut-off modes, the
charger's output will shut off when the proper voltage is
reached. You should monitor the charging process at least
daily to ensure that the battery's electrolyte level is proper
and that the battery does not over charge. When the
charger's output does shut off, the green "Charge
Complete" light comes on. The transformer of the charger
is still on so it is normal to hear a humming or buzzing
L
The ammeter built into this charger indicates the
amperage that the battery is drawing from the charger.
The meter will read the maximum output rating of the
charge setting selected only if the battery being charged is
fully discharged.
The "Battery" area in red at the top of the meter gives an
approximation of the battery's state of charge. The needle
will move from right to left as the battery approaches full
charge (12 volt only).
When set to an Automatic Shut-off position (the "Select
Function" switch is in the "Charge" position and the "Select
Setting" switch is in one of the 12 volt positions), the
battery charger will automatically shut off when the battery
has been fully charged.
The 6 volt setting is a constant current setting and the
needle will not move from right to left (not applicable to the
87122).
All manuals and user guides at all-guides.com
RATE SELECT
LOW HIGH &
START
ABOUT THE AUTOMATIC CIRCUITRY
READING THE METER & TIME TO CHARGE
Step 2: Set VOLT SELECTOR (Bottom
Switch)
Select "6 Volt" for
charging and starting 6
volt batteries used in
automobiles, trucks and
farm equipment.
Select "12 Volt" for
charging and starting 12
volt batteries used in automobiles, lawn tractor,
motorcycle, trucks and farm equipment.
After you have read the owner's manual and
completed the steps required in sections "A" through
"J", the charger can be plugged in and used.
noise as the charger continues to monitor the battery
charge level. If the green "Charge Complete" light does
not come on at least once in a day's charging, set the
"Select Setting" switch to "Start" ("Activate" on 87122). If
the green "Charge Complete" light does not come on
within 30 minutes, discontinue charging and read section
"M", TROUBLESHOOTING. Continuing to charge may
damage the battery.
Charge
Rate
2 AMP Motorcycle Batteries
Snowmobile Batteries
Lawn Tractor Batteries
10 AMP Automotive Batteries
Tractor Batteries
Truck Batteries
12 AMP Automotive Batteries
Tractor Batteries
Truck Batteries
15 AMP Automotive Batteries
Tractor Batteries
Truck Batteries
30 AMP Large Automotive Batteries
Large Truck Batteries
Large Tractor Batteries
7
VOLT SELECT
6 VOLT OFF 12 VOLT
Approximate
Hours
Uses to Charge
2-8
3-5
2.5-4
2-4
1-4
E
n
g
l
i
s
h