Msr Installation; Wood Stud Instructions (Option A); Select Mounting Location - CHIEF MSR Instrucciones De Instalación

Installation Instructions

MSR INSTALLATION

Select one of the following options to mount the MSR.
•

Wood Stud Instructions (Option A)

•
Concrete Instructions (Option B)
•
Dry Wall Instructions (Option C)
Wood Stud Instructions (Option A)
Perform the following procedures to mount the MSR on
wood studs using lag screws:

Select Mounting Location

To select the mounting location, do the following:
NOTE: Read the Warnings and Cautions on page 2.
1. Determine the exact mounting location to install the
wall mount prior to installation, keeping in mind the
screen size.
NOTE: Mount the MSR on wall studs or some other
equivalent supporting framework that is vertical
or horizontal.
2. Using a stud sensor, locate the wood stud(s) where
you will mount the MSR, as follows:
•
Refer to Figure 1 for single wood stud mounting.
OR
•
Refer to Figure 2 for dual wood stud mounting,
wood studs that are 16"apart on center.
3. Draw a level plumb line to indicate the desired height
of the mount.
4. Holding the MSR against the wall, select the
mounting holes that best suits your situation (see
Figure 3 on page 5).
NOTE: For dual wood stud mounting, the holes are
slotted to allow for lateral movement. The mount
can be centered, or shifted to the left of center, or
shifted to the right of center depending on stud
location.
5. Mark the mounting holes you selected in Step 4.
Make sure the mounting holes are square and
straight.
6. Lay the MSR down on the floor.
7. Drill the pilot holes into the center of the wood
stud(s) at the locations marked in Step 5 using the
correct drill bit.
4
Wall
Figure 1. Drill Single Stud Pilot Holes
Wood Studs
Wall
Figure 2. Drill Dual Stud Pilot Holes
MSP-DCCPOR
Wood Stud
Pilot Holes
16"
Pilot Holes
Pilot Holes