Dry Wall Instructions (Option C) - CHIEF MSR Instrucciones De Instalación

Installation Instructions

Dry Wall Instructions (Option C)

Perform the following procedures to mount the MSR on
dry wall using anchors:
NOTE: Read the Warnings and Cautions on page 2.
1. Determine the exact mounting location to install the
wall mount prior to installation, keeping in mind the
screen size.
2. Using the MSR mount as a template, mark the
location of the four mounting holes.
3. Drill a ½" hole at the desired location, making sure
the wall is at least ½" thick. If the wall is made with
metal studs, it is recommended to install the anchor
through the drywall and the metal stud (see Figure 5).
4. With plastic anchor (50) inserted in hole, slide finger
grip together to turn end inside hole perpendicular to
wall (see Figure 6).
5. Slide plastic ring of anchor to the surface of the wall
(see Figure 7).
6. Split finger grip ends apart to break plastic ends off
flush with plastic ring of anchor (see Figure 8).
7. Repeat Steps 1 through 6 to install the remaining
three anchors.
8. Using four ¼"–20 Phillips head screws (60) and four
flat washers (70), secure the MSR mount to the wall
(see Figure 9).
Figure 5. Drill Hole for Plastic Anchor
Figure 6. Insert Plastic Anchor into Hole
Figure 7. Slide Plastic Ring to Wall Surface
BREAK OFF
PLASTIC ENDS
Figure 8. Cut Anchor Ends to Make Flush with Wall
60
70
Figure 9. Secure Mount to Wall
MSP-DCCPOR
10
7