Install The Display; Remove The Display - CHIEF MSR Instrucciones De Instalación

Installation Instructions
NOTE: In general, most displays are mounted in the
landscape orientation as shown in Figure 12.
Dell LCD displays can be mounted in the portrait
orientation for specific situations. Before
mounting your display, see the owner's manual
for proper display orientation.

INSTALL THE DISPLAY

To install the display, do the following:
NOTE: Verify that all
disconnected from the display and the latching
flag is lowered in the down position before
attempting to mount the display.
1. With the aid of another person, lift the display up to
the mount (10) on the wall. Align the mounting
buttons on the interface bracket (80) with the
teardrop slots on the mount, and lower the display
firmly into place (Figure 12).
2. Raise the latching flag to secure the display (see
Figure 13). If the flag does not fully engage, check to
ensure the mounting buttons are fully seated in the
slots.
NOTE: A padlock may be installed through the hole in
the latching flag for additional security.

REMOVE THE DISPLAY

To remove the display from the mount, do the following:
1. Disconnect all power/audio/video cables.
2. Lower the latching flag to unlock the display (see
Figure 13).
3. With the aid of another person, lift the display up and
out of the teardrop slots in the mount to remove the
display.
power/audio/video cables
are
10
Figure 12. Install the Display
Latching Flag
Figure 13. Raise Latching Flag to Lock
Display
80
Lock
Unlock
MSP-DCCPOR
Teardrop Slot
9