Attach Interface Bracket To Display; Option A; Option B - CHIEF MSR Instrucciones De Instalación

Installation Instructions
ATTACH INTERFACE BRACKET
TO DISPLAY
The interface bracket can be attached to the display using
two different sets of mounting holes.
Depending on the mounting-hole configuration on your
display, select the procedure that matches your display.

Option A

1. Select six M6 screws (90) and six spacers (100) from
parts bag.
2. Place display face down on a clean dry surface.
3. Install six M6 screws (90) into the six mounting holes
on the interface bracket (80). See Figure 10.
4. Slide six retaining spacers (100) onto six M6 screws
(90).
NOTE: The arrow on the interface bracket (80) must
point toward the top of the display.
5. Align interface bracket (80), with screws (90) and
spacers (100), with mounting holes in display back.
6. Tighten all screws.

Option B

1. Select four M6 screws (90) and four spacers (100)
from parts bag.
2. Place display face down on a clean dry surface.
3. Install four M6 screws (90) into the four mounting
holes on the interface bracket (80). See Figure 11.
4. Slide 4 retaining spacers (100) onto four M6 screws
(90).
NOTE: The arrow on the interface bracket (80) must
point toward the top of the display.
5. Align interface bracket (80), with screws (90) and
spacers (100), with mounting holes in display back.
6. Tighten all screws.
8
Arrow must
point to top
of display
90
100
Figure 10. Attach Interface Bracket – Option A
Arrow must
point to top
of display
90
100
Figure 11. Attach Interface Bracket – Option B
MSP-DCCPOR
80
Display
80
Display