Technoline WS 6502 Manual Del Usuario página 13

seasons. Do not place the unit in area of high winds.
3. Do not place the remote temperature sensor more than 30 meters (96 feet) from the receiving
weather station unit. The remote temperature sensor is more effective if there are no obstructions
and interference between the remote temperature sensor and the weather station. The remote
temperature sensor might have to be closer than 30 meters if the weather statioin is not able to
receive signals.
experiment with various locations to get the best reception.
4. If there is a change in power source in the main unit (i.e from batteries to AC-DC adatper or vice
versa), press "TX" button (RTS 3) on the remote temperature sensors to reconfigure remote
temperature sensors. See figure 5.
CONFIGURING WEATHER STATION UNIT TO RECEIVE REMOTE TEMPERATURE SIGNALS
1. Follow the above insructions to set up remote temperature sensor.
Press "Channel" button (7) on weather station for 3 seconds. The symbol
2.
reset all temperature memories.
3. The weather station will begin scanning for signals for channel 1. As soon as signals are recevied
from channel 1, the temperature will be displayed. The weather station will automatically scan for
other channels. It will scan each channel for approximately 3 seconds before skipping to the next
chaneel.
Once all your channels are received by the unit, press "Channel" button (7) once to confirm the
4.
channel. The symbol
5. The weather station will receive a new signal automatically every 30 seconds to update the remote
temperature.
Press "Channel" button (7) on weather station repeatedly to select between channel 1, channel 2,
6.
and channel 3.
7. The symbol
sensor's batteries need replacing.
TEMPERATURE MEMORY
Press "Max/Min" button (4) to display maximum recorded temperature, minimum recorded temperature
and current temperature. "max" indicates maximum temperature. "min" indicates minimum temperature.
TEMPERATURE DISPLAY
The "IN" temperature displays the indoor temperature. It is the temperature of the actual location
1.
of the weather station.
The "OUT" temperature displays the temperature of the remote temperature sensors.
2.
Press "Channel" button (7) on weather station repeatedly to display the temperature of channel 1,
3.
channel 2, and channel 3.
°C/°F DISPLAY
PRESS "+/C/F" button (4) to select between displaying the temperature in Celsius or Fahrenheit.
TEMPERATURE TREND
1. Indicates the temperature trend is increasing.
2. Indicates there is a stable temperature trend.
3. Indicates the temperature trend is decreasing.
SPECIFICATIONS
1. Indoor temperature range : -10'C ---- 70'C
2. Outdoor temperature range : -40'C ---- 70'C
3. Barometeric pressure range : 900mb --- 1050 mb.
This may be due to obstructions and or interference. The user might need to
will no longer be displayed.
will be displayed on the weather station unit if any of the remote temperature
6
will flash. This will