Sunny SF-B1851 Manual Del Usuario página 14

ADJUSTMENTS AND USAGE GUIDE
5
76
37
21
2
22
ADJUSTING THE HEIGHT AND BALANCE
In order to achieve a smooth and comfortable ride, you
must ensure that the stability of the bike is secured. If you
notice that the bike is unbalanced during use, adjust the
Adjustment Foot Pads (No. 37), located beneath the
Front & Rear Stabilizers (No. 5 & No. 6) of the bike. To
do so, use Wrench (No. 96) to loosen Hex Thin Nut (No.
76) by turning it clockwise (direction A). With the nut
loosened, rotate the Adjustment Foot Pad (No. 37) until
6
it sits level with the surface that the bike is on. When you
have finished adjusting the Adjustment Foot Pad (No.
37), re-tighten the Hex Thin Nut (No. 76) by turning it
S17
counter-clockwise (direction B) to complete the balance
#96 S17-S19 1PC
adjustment of the bike. If needed, repeat this process to
adjust the remaining Adjustment Foot Pads (No. 37).
ADJUSTING THE RESISTANCE
Adjust the resistance of the bike using the Tension
Control Knob (No. 21). Increase the level of resistance by
turning the Tension Control Knob (No. 21) to the RIGHT
(clockwise), decrease the level of resistance by turning the
Tension Control Knob (No. 21) to the LEFT (counter-
clockwise).
EMERGENCY BRAKE
During use, users can stop the bike completely by pushing
down on the Tension Control Knob (No. 21). Pushing
down on the Tension Control Knob (No. 21) will enforce
the brake and bring the bike to an immediate stop.
ADJUSTING THE SEAT
The seat of this bike is fully adjustable as it moves Up,
Down, Fore (forward), Aft (backward).
To adjust the height of Seat Post (No. 2), loosen and pull
the Adjustment Knob (No. 22) outward, then raise or
lower the seat to the desired height. Once adjusted, re-
insert and tighten the Adjustment Knob (No. 22) to secure
the Seat Post (No. 2) in place.
To adjust the seat back and forth, loosen and pull the
Adjustment Knob (No. 22) outward, then slide the Seat
22
Slider (No. 8) to desired position. Once positioned, re-
insert and tighten the Adjustment Knob (No. 22) to secure
8
the Seat Slider (No. 8) in place.
13