Setting The Temperature; Setting The Display Brightness - Dometic CFF12 Instrucciones De Uso

Operation
I
NOTE
CFF35, CFF45: When latching the lid, ensure that both latch side pins
are fully engaged to ensure a good lid seal. One latch may engage
slightly before the other.
If the lid is not closed equally at both sides, press until a second click is
heard.
6.6 Fixing the cooler while transporting (CFF12)
When transporting the cooler in a vehicle, you can fix the device with the safety seat
belt or with luggage tighteners so that it remains in its position.
!
WARNING!
Make sure that the cooler is fixed correctly. Otherwise it could be dis-
lodged and cause severe injuries to passengers when a hard break
occurs.
Fixing with a safety seat belt
➤ Proceed as shown (fig. 0, page 8).
Fixing with luggage tighteners
➤ Proceed as shown (fig. a, page 8).
6.7

Setting the temperature

1. Press the "SET" button (fig. 3 5, page 4) once.
2. Use the "UP +" (fig. 3 7, page 4) and "DOWN –" (fig. 3 6, page 4) buttons to
select the cooling temperature.
✔ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
6.8

Setting the display brightness

The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
1. Switch on the cooler.
2. Press the "SET" button four times (fig. 3 5, page 4):
3. Use the "UP +" (fig. 3 7, page 4) or "DOWN –" (fig. 3 6, page 4) buttons to
set the brightness of the display.
22
CFF12, CFF35, CFF45
EN