Double Din Head Unit Provision - Metra 99-7338B Manual Del Usuario

Double DIN head unit provision

1. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
2. Cut and remove the center bar from the
radio housing. (Figure A)
3. Snap the double DIN brackets to the
inside edge of the double DIN trim plate.
(Figure B)
4. Slide the Double DIN head unit or into
the bracket/radio housing assembly
and secure the Double DIN head unit or
stacked ISO head units to the assembly
using the screws supplied with the
radio. (Figure C)
5. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-7338B
7
(Figure A)
(Figure B)
(Figure C)