P
M
ATENTED
OTION
When the iron is plugged in, the Power Indicator will light steadily, indicating that there
is power to the iron.
If you leave the iron:
• in a horizontal position without moving it, or accidentally tip the iron over, it will
automatically stop heating after 30 seconds. The Power Indicator will blink to let
you know that the iron has stopped heating.
• in a vertical position (on its heel rest) without moving it, the iron will automatically
turn off after 15 minutes. The Power Indicator will blink to let you know that the
iron has stopped heating.
I
: The Power Indicator will continue to blink until the iron is unplugged or reset.
MPORTANT
To reset the iron:
Move the iron back and forth and allow it to reheat for 2 minutes. The indicator will
stop blinking and the iron will start heating again.
WARNING: The patented MOTION SMART
recommended means for turning your iron off. See "Caring for Your Iron After Use"
for information on turning off your iron and storing it safely between use.
C
ARING FOR
T
O
URNING
FF
1.Turn the Steam Lever to
2.Unplug the iron from the power source.
WARNING: NEVER yank the power cord when unplugging the iron.
This can damage the cord.
S
Y
TORING
1.Allow the iron to cool.
2.If you do not use your iron on a daily basis, empty the water reservoir after each
use for a longer iron life. To do so, unplug the iron, turn the iron upside down,
open the fill hole cover, and allow water to flow from the fill hole. Shake the iron
gently to remove trapped water drops.
3.Loosely loop the power cord around the heel rest and store the iron on its heel rest.
I
: Wrapping the cord around the iron too tightly can damage the cord.
MPORTANT
T
: When not ironing, always set the Steam Lever to O/Off (Dry) and the Fabric Select
IP
Slide to Off.
All manuals and user guides at all-guides.com
®
S
A
MART
Y
Y
I
OUR
RON
O
/Off (Dry) and Fabric Select Slide to Off.
I
OUR
RON
-O
F
UTO
FF
EATURE
®
Auto-Off is a safety feature, not a
I
OUR
RON
(select models only)
A
U
FTER
SE