English; General Safety Information; Work Area Safety; Electrical Safety - EGAmaster 56060 Manual De Instrucciones

ENGLISH

WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious personal injury.
• Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids,
gases, or dust. Tools create sparks which may ignite the dust or fumes.
• Keep bystanders, children, and visitors away while operating a tool. Distractions can cause you to lose
control.
• Keep floors dry and free of slippery materials such as oil. Slippery floors invite accidents.
• Guard or barricade the area when work piece extends beyond machine. A guard or barricade that
provides a minimum of three (3) feet clearance around the work piece will reduce the risk of entanglement.
• Grounded tools must be plugged into an outlet, properly installed and grounded in accordance with
all codes and ordinances. Never remove the grounding prong or modify the plug in any way. Do not use
any adapter plugs. Check with a qualified electrician if you are in doubt as to whether the outlet is properly
grounded. If the tool should electrically malfunction or break down, grounding provides a low resistance path
to carry electricity away from the user.
• Avoid body contact with grounded surfaces. There is an increased risk of electrical shock if your body is
grounded.
• Don't expose electrical tools to rain or wet conditions. Water entering a tool will increase the risk of
electrical shock.
• Do not abuse cord. Never use the cord to carry the tools or pull the plug from an outlet. Keep cord away
from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords increase
the risk of electrical shock.
• Use only three-wire extension cords which have three-prong grounding plugs and three-pole receptacles
which accept the tool's plug. Use of other extension cords will not ground the tool and increase the risk of
electrical shock.
• Keep all electric connections dry and off the ground. Do not touch plugs or tool with wet hands. Reduces
the risk of electrical shock.

GENERAL SAFETY INFORMATION

WORK AREA SAFETY

ELECTRICAL SAFETY

11