Tabla de contenido
Publicidad
English
Installation Considerations
• For best results, Hansgrohe recommends that this
product be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The SAM Set Plus may be used to replace the
shower arm and showerhead in an existing shower.
This manual does not provide instruction on removal
of the old shower arm. It may be necessary to
correct the existing plumbing before the SAM Set
Plus can be installed.
• The toggle bolts included with this set are suitable
for use in a tile or other solid surface wall. They
are not suitable for use in an acrylic or fiberglass
Product Notes
• It is not possible to use the showerhead and the
handshower simultaneously.
• The diverter on the SAM Set Plus does not turn the
water off.
This product is intended as a showerhead
support only. Do not hang other items
from the shower arm or wallbar.
2
shower enclosure. Please contact the manufacturer
of the enclosure regarding recommended mounting
locations,
reinforcement
mounting hardware.
• Protection against backflow is provided by check
valve and by self-resetting diverter.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts, the
maximum output temperature can be no higher
than 112°F (44°C).
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Do not use this product as a grab bar.
The
adjustable
(slider) on this model should not be used with
a handshower with a spray face larger than
125 mm (5") in diameter.
requirements,
handshower
holder
and
Publicidad
Tabla de contenido
