Sebson AC SENSOR B Manual Del Usuario página 7

General safety information:
Danger:
In case of damages or contact with water turn off this product immediately without tension and make sure
that a restart is no longer possible!
Danger of suffocation:
parts that can be swallowed!
Caution:
Avoid overloading the device, an overload can damage the device or cause a short circuit! Therefore,
please note the maximum power consumption in the technical data!

The remodeling of this product is not allowed! The proper and safe functioning of the device can no longer
be guaranteed if it is modified! In addition, this will invalidate the warranty claim!

The manufacture does not accept any responsibility for injuries or damage resulting from improper use of
this product!

Any other use than the description may result in damage to the product. So the dangers are such as
electric shock, short circuit, fire etc.

We reserve the right to make changes to the product, the packaging or the operating instructions as well as
printing errors.

This product is only suited for indoor-use and not for outdoor-use!

Protect the product from external damage, heavy dirt, moisture and excessive heat!

In order that the warranty claim does not expire please use only the supplied items. Repairs may only be
done by an expert and only by using original spare parts!

In commercial institutions, the accident prevention regulations of the professional trade association for
electrical equipment and facilities must be adhered to.
Start up:
Danger:
Do not close several switches consecutively! Danger of overheating!
Attention:
Take the product out of the socket if you do not use the product for an extended period of time!
Note:
After connecting the unit to a power socket, several clicking sounds are heard in quick succession. The
clicking sounds signal the warm-up phase. After approx. 30 seconds, the unit is ready for operation.

Please observe the safety instructions and technical data before installing this product!

Operate this product at a suitable power outlet (230V AC 50Hz).
Explanation of the functions of the slider:
On: Socket ready for operation, Sensor deactivated
OFF: Switched off
AUTO: Socket ready for operation, Sensor activated
To ensure optimum sensitivity of the sensor, install the device in the room in such a way that the movements are
transversely to the device. Movements that are directly to and from the device are less well detected. (see Fig. 4a).
Do not operate the device in the immediate vicinity of (see also Fig. 4b):

Metal surfaces e.g. metal door frames

electronic devices such as computers, monitors etc

Heat sources e.g. radiant heaters, radiators or lamps

fume cupboards or fans

luminaires (minimum distance from luminaires >50cm)
Please keep this product away from children and animals. The packaging contains small
7