TRANSFERRING THE SOUND TO YOUR SOUND BAR VIA OPTICAL INPUT
If your television has an S/PDIF optical output, you can use optical cables (not supplied) to connect your
television to the base, then transfer the sound to a sound bar.
1.
Plug one end of your optical cable into the
optical input on the base, and plug the other
end into the optical output on your television.
2.
Plug one end of a second optical cable into
the optical output on the base, and plug the
other end into the optical input on your sound
bar.
20
INPUT
OUTPUT
OPTICAL
OPTICAL
2
1
Optical cable
Optical cable
(not included)
(not included)
OUTPUT
OPTICAL
INPUT
OPTICAL
use
Turning the headphones on and off
•
To turn the headphones on, press and hold the on/off button
for around 2 seconds. The LED light on the headphones turns blue.
•
To turn the headphones off, press and hold the on/off button
for around 2 seconds. The LED light on the headphones flashes
blue, then goes off.
Comments:
- Once the wireless headphones have switched on, they
automatically connect to the base. This takes between 5 and
10 seconds. The LED light on the base turns blue. The LED light on
the headphones flashes blue and beeps 3 times; this means that
the headphones and the base have successfully paired.
- If you place the headphones on the base when they are switched
on, they will automatically switch off.
Pairing the headphones and the base
The headphones and the base are paired during production in the factory. However, you can use the
following procedure to carry out a new pairing process.
•
Plug the base into a mains outlet.
•
Turn the headphones on.
•
Press and hold the mute button on the headphones for at least
3 seconds. The LED light on the headphones starts flashing.
•
Press and hold the pairing button on the bottom of the base
for at least 3 seconds. The LED light on the base starts flashing.
•
When both the light on the base and the light on the headphones
stop flashing and a beep is heard, this means that the pairing was
successful.
21