Makita AR410HR Manual De Instrucciones página 7

Continuous Drive Method
009770
(2)
009768
Continuous drive is where the contact arm is repeatedly
pressed onto different areas of workpiece while the
trigger is held down to continuously drive in screws.
Set the switching lever to the
"Continuous Drive Mode".
(1) Pull trigger.
(2) With the trigger held down, each time the
contact arm is pressed against the workpiece,
a screw will be driven in continuously.
Trigger Locking Method
This driver has a trigger lock to prevent accidents due to
mistaken operation when main unit is not being used.
The trigger lock is a mechanism that locks the trigger,
preventing discharge of screws.
Set the switching lever to the
"Trigger Lock".
When drive screws, set lock lever to the
position. When not using the driver, always lock the
trigger and disconnect the air hose.
How to Cut linked Sheet
009775
1. Lever
1
position to set driver to
position to set driver to
position or
CAUTION:
When cutting linked sheet, always lock trigger, and
•
disconnect air hose.
When using linked screws, the linked sheet protrudes
from the driver guide. Tear away the protruding linked
sheet in the direction of the arrow.
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool before
•
attempting to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may result.
How to Rectify Screw Jam
CAUTION:
When rectifying screw jam, always lock trigger, and
•
disconnect air hose.
2
009776
Lock trigger and disconnect air hose.
Open door, and pull out linked screws.
Insert thin metal bar into discharge nose, and hit it with a
hammer. In some cases, this metal bar will become
stuck when hit. Note, that at such times, the bit must not
be hit, as the bit end may be damaged, and lead to
impaired screw driving.
2
009777
Remove screw(s) jammed inside driver guide using
minus screwdriver or other such tool.
After removing screw(s), make sure bit is not protruding
into screw channel (if it is, press it out of the way using
the metal bar).
After removing the jammed screw(s), reload the driver
with screws.
7
1. Hammer
1
2. Bar
1. Screw
1
2. Screwdriver