Sauder Office Port 408294 Instrucciones De Montaje página 16

Step 12
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (F) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a PULL (96K) to the DOOR (F). Use two BLACK 1"
å
PAN HEAD SCREWS (60S).
Repeat this step for the other DOOR (F).
å
See the next step for DOOR adjustments.
å
BLACK 1" PAN HEAD SCREW
(4 used in this step)
Page 16
96K
60S
B
F
408294
Stop
Mounting
screw
Hinge
www.sauder.com/services