Cleaning And Maintenance - Aigostar 8433325185879 Manual Del Usuario

7. Always turn off the milk frother and disconnect the power supply when not use.
II. Only frothing separately, without heating
1. According to the 1-4 steps in the section of "Frothing and heating".
2. Press the switch button for three times continuously within 2s, the indicator
will illuminate blue and blink, the frothing paddle will rotate for frothing milk
separately, but the heating element will not heat. And the appliance will
automatically stop rotating after operating. The indicator will illuminate red
again until unplugging the power outlet.
Note: During operation, you can stop operating by pressing the switch
button once.
3. When the appliance has stopped operating, open the lid, pour out the
frothed milk andenjoy it.
Caution: Minimum 3 minutes rest time must be maintained between two
continuous cycles, otherwise, the appliance will enter self-protection state
automatically after working for 5 cycles continuously, the working indicator
will flash and the switch button will not be activated, after about 5 minutes,
the appliance will enter standby state and you can continue operating the
appliance.
4. Always turn off the milk frother and disconnect the power supply when
not use.
III. Only heating separately, without frothing.
1. Place the appliance on a flat surface.
2. Select mixing paddle according to your task. Then open the lid, insert the
mixing paddle onto the shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk(the initial temperature of milk is
5-10°C), and replace the lid.
NOTE: the max milk quantity permitted to add is 200ml, to avoid milk
overflowing after mixing or frothing.
4. Place the jar on the power base and connect the plug into a power outlet.
The indicator will illuminate red.
5. Press the switch button twice continuously within 2s, the indicator will light
blue. Then the appliance will start to work. Once the temperature of milk has
achieved about 65±10℃, the heating element will stop heating and the mixing
paddle will stop rotating automatically; the indicator will illuminate red again
until unplugging the power outlet.
Note: The rotation of mixing paddle is only used for avoiding sticking. It will
not froth the milk.
05
All manuals and user guides at all-guides.com
6. When the appliance has stopped operating, open the lid, pour out the
warm milk and enjoy it.
Caution: Minimum 3 minutes rest time must be maintained between two
continuous cycles, otherwise, the appliance will enter self-protection state
automatically after working for 5 cycles continuously, the indicator will be
illuminated blue and flash, the switch button will not be activated, after about
5 minutes, the appliance will enter standby state and you can
continue operating the appliance.
7. Always turn off the milk frother and disconnect the power supply when
not use.

CLEANING AND MAINTENANCE

Always disconnect the appliance from the power outlet and allow it cooling
down before cleaning.
CAUTION: Never immerse the jar, power base in water, or allow moisture to
contact with these parts.
1. Wash lid with water and mild detergent. The lid is not dishwasher safe
component. Rinse thoroughly and dry.
2. Remove the mixing paddle or frothing paddle, and wash them completely
in warm water.
3. Wash the inner of jar with a combination of a mild detergent and water
and then wipe clean with a soft damp cloth.
4. Wipe the appearance of jar with a soft damp cloth or cleaner, never use
a poisonous cleaner.
NOTE: Do not use chemical, steel, wooden or abrasive cleaners to clean the
outside of the appliance to prevent the gloss loss.
ENVIRONMENT FRIENDLY DISPOSAL
WARRANTY: 2 YEARS
You can help protect the environment!
Please remember to respect the local
regulations: hand in the non-working
electrical equipment to an appropriate
waste disposal center.
06