Antec New Solution Serie Manual Del Usuario página 5

2. Connect the Reset switch (labeled RESET SW) to the motherboard at the RST
connector. Make sure the label always faces the front of the case.
3. Power LED (labeled POWER LED) connector is located behind the Reset
connector.
4. Power Switch (labeled POWER SW) connects to the PWR connector on the
motherboard.
5. Hard Drive LED (labeled H.D.D. LED) connects to the IDE connector.
USB Connection
You will find a single 10-pin connector on a cable attached to the front USB ports.
This is an Intel standard connector, which is keyed so that it can't be accidentally,
reversed as long as it is connected to a proper Intel standard motherboard header.
Connect the 10-pin connector to the motherboard headers so that the blocked pin
fits over the missing header pin.
Note: Please check the motherboard manual for the USB header pin layout and
make sure it matches the attached table. If it does not match this Intel standard,
please call Antec customer support at (800) 22ANTEC (North America) or at
+31 (0) 10 462-2060 (Europe) to buy a USB adapter. This adapter will allow you
to connect the front USB to the motherboard on a pin-by-pin basis.
1 2
9 10
Connecting the IEEE 1394 (FireWire®, i.Link®) Port
You will find a single 10-pin connector on a cable attached to the front IEEE 1394
connection. This is an Intel standard connector, which is keyed so that it can't be
accidentally reversed as long as it is connected to a proper Intel standard
motherboard header. Connect the 10-pin connector to the motherboard header so
that the blocked pin fits over the missing header pin.
Note: Please check the motherboard manual for the IEEE 1394 header pin layout
and make sure it matches the attached table. If you intend to connect the front
FireWire® port to an IEEE 1394 add-on card that comes with an external-type IEEE
1394 connector, please call Antec customer service at (800) 22ANTEC
(North America) or +31 (0) 10 462-2060 (Europe) to buy an adapter. This adapter
will allow you to connect the front IEEE 1394 port to the external-type connector.
All manuals and user guides at all-guides.com
Motherboard Pin Layout
Pin Signal Names
1
USB Power 1
3
Negative Signal 1
5
Positive Signal 1
7 Ground 1
9
Key (No Connection)
Pin
2
4
6
8
10
3
Signal Names
USB Power 2
Negative Signal 2
Positive Signal 2
Ground 2
Empty Pin